How to Fix a Pop-Up Sprinkler Head That Leaks

It is common for an ordinary sprinkler head to spill over or leak for several different reasons. Repairs are basically easy to perform with the use of some simple ways. The following are some steps that will help you assist in resolving leakage problems common to pop-up sprinkler heads:

1. Conduct a Visual Examination

The first method to repairing the leakage is knowing where it is located. In order to do this step, you should first turn on your sprinkler and thoroughly watch where the water is escaping. Leaks at different spots can be associated to various causes. Examine if the water leaks where it sprays out of the sprinkler head or if it is below or above the sprinkler head itself. Also, water can spray out from the ground below or the sprinkler housing. While you can DIY, it’s still highly advised that you hire a Sprinkler Repair Company Austin.

2. Inspect Your Sprinkler Head Assembly

If the water is escaping out of the sprinkler head, it may be damaged, clogged or loose. It will be simpler to inspect the head for any problems if you get rid of it, therefore, use a spade in order to excavate down below. Most sprinkler heads are actually removed through twisting the cap off the top of your sprinkler housing or body. The cap basically holds the shaft which pop ups when the water pressure is added. The cap also keeps the water from escaping out of its body. Check the seal below and push up on the body in order to expose the head of the sprinkler.

Most sprinkler heads unscrew from the body. Once you have removed it, turn the body upside down and then shake it. This way, the filter or screen inside should be dislodged. If not, make use of the long flat screwdriver to push out the filter from the bottom up. In addition to that, check the filter for any kinds of debris. If it is present, flush it with running water.

Check the sprinkler head you have removed. See if the debris is lodged in the spray area of your sprinkler head. Look also at the threads of your sprinkler housing for damages. If there is damage or debris present, the head will have to be changed. If not, resume the checkup.

3. Check the Fitting and the Riser

If you can see the water below the sprinkler shaft, the leak might be at the fitting or the riser. Use a spade to excavate to the riser and turn on the water valve. Look for any signs of leaks at the fitting or riser. If so, you will have to change it with a new one.

In the moment that the water still leaks where the riser is attached to the fitting, you will also want to get rid of the riser. Check both ends of the threads for any damage or leaks. Reattach if the threads are free of leaks and turn on the water valve. If leak is still present, you can wrap it up with a tape or water-tight seal around the threads 2 or 3 times prior to testing it again.